Starting the Vehicle
Applies to: vehicles with convenience key
Fig. 94 Center console: starting the engine
Requirement: the key must be in the vehicle.
Starting the Engine
- Press and hold the brake pedal.
- Press the [START ENGINE STOP] button. The engine will start.
Equipment that uses a lot of electricity is switched off temporarily when starting the engine. If the engine does not start immediately, the procedure stops automatically after a short time. Repeat the procedure after approximately 30 seconds.
Stopping the Engine
- Bring the vehicle to a full stop.
- Press the [START ENGINE STOP] button. The engine will switch off.
Applies to vehicles with steering lock: the steering is locked when the engine is switched off and the driver’s door is opened. This helps prevent theft. On vehicles with automatic transmission, “P” must be engaged.
Stopping the Engine in an Emergency
The engine can also be stopped while driving using the emergency off function.
- Press the [START ENGINE STOP] button twice in a row or press and hold it once.
Switching the Ignition On and Off
To switch the ignition on or off without starting the engine:
- Press the [START ENGINE STOP] button without pressing the brake pedal.
Switching the Ignition Off Automatically
To prevent the battery from draining, the ignition and exterior lighting may switch off automatically.
Requirements:
- The Start/Stop system has stopped the engine.
- The vehicle has been exited for longer than 30 seconds.
- The ignition is switched on.
The system detects that you have left the vehicle if:
- The driver’s door is opened.
- The driver’s seat belt is unbuckled.
- The brake pedal is not pressed.
The ignition will also switch off after 30 minutes or when the vehicle is locked from the outside.
Warning
- Never allow the engine to run in confined spaces to reduce the risk of asphyxiation.
- Never turn off the engine before the vehicle has come to a complete stop. This may impair braking and steering assistance.
- Secure the vehicle against rolling before exiting.
Note
- Avoid high engine speed and heavy load until the engine reaches operating temperature.
- After heavy engine load, let the engine idle for about two minutes before switching it off.
Tips
- Brief noises during starting and parking are normal.
- The radiator fan may continue to run for up to 10 minutes after engine shutdown.
- Starting may not be possible in extremely low temperatures.
- Full power is available once the engine reaches operating temperature.
System Messages
Engine start system: malfunction! Contact an authorized Audi dealer or service facility.
Remote control key not detected: The key is no longer in the vehicle. The engine cannot be restarted once switched off.
Hold key against designated area: The key battery may be drained. Hold the key against the marked area to start the vehicle.
Starting to Drive
- Press and hold the brake pedal.
- Start the engine.
- Select “D” or “R”.
- Release the parking brake.
- Release the brake pedal.
- Press the accelerator pedal.
Securing the Vehicle Against Rolling
- Set the parking brake.
- Select “P”.
- Turn the steering wheel toward the curb on steep roads.
If vehicle power is unavailable, use wheel blocks and only park on level surfaces.
Hill Hold Assist
Hill hold assist holds braking force for several seconds on inclines.
Requirements: driver’s door closed, engine running, vehicle facing uphill.
- Press and hold the brake pedal for several seconds while stationary.
