Mitsubishi L200 19MY L200 2018-2020 Super Select 4WD II* Car Owner Manuals

Super Select 4WD II*

Shifting to rear-wheel drive or 4-wheel drive can be made by operating the drive mode-selector (A). Set the drive mode-selector to an appropriate position according to road surface conditions. The 2WD/4WD operation indication lamp and low-range indication lamp indicate the drive mode-selector setting state. Refer to “2WD/4WD operation indication lamp and low-range indication lamp” on page 6-42.

Drive Mode-Selector Position and 2WD/4WD Operation Indication Lamp

CAUTIONS

• The “4LLc” range gives maximum torque for low-speed driving on steep slopes, sandy, muddy, or other difficult surfaces. Do not exceed ~70 km/h (43 mph) in “4LLc” with A/T.
• Do not drive in “4HLc” or “4LLc” on dry paved roads and highways to avoid excessive tyre wear, increased fuel consumption, noise, or drive system damage. Use “2H” or “4H” on paved roads only.

Drive Mode-Selector Operation

The drive mode is shown on the drive mode-selector knob. Turn or turn while holding down as needed. Position the selector according to the following conditions:

NOTES

• Setting between 2H, 4H, and 4HLc should be below 100 km/h (62 mph).
• Do not shift from 4HLc to 4LLc while driving.
• Transfer gear may make noise in cold weather; stop vehicle if necessary.
• While stopped, 2WD/4WD lamps blink during selection; drive slowly after illumination.
• Do not operate selector while rear wheels are slipping on snow or ice.

2WD/4WD Operation Indication Lamp and Low-Range Indication Lamp

A - Front wheel lamp
B - Centre differential lock lamp
C - Rear wheel lamp
D - Low-range indication lamp

When ignition switch is ON or operation mode is ON, lamps indicate shifting condition:

2H ↔ 4H

• 2H: Drive mode switching in progress
• 4H: Blink / Illuminate / Remain off as indicated

4H ↔ 4HLc

• 4H: Drive mode switching in progress
• 4HLc: Blink / Illuminate / Remain off as indicated

4HLc ↔ 4LLc

• 4HLc / 4LLc: Blink / Illuminate / Remain off as indicated

NOTES

• Front and/or centre differential lock lamps blink during 2H ↔ 4H ↔ 4HLc selection. Keep steering straight. Drive slowly after illumination.
• During 4HLc ↔ 4LLc shifting, front and rear lamps blink until fully illuminated.

NOTE: When parking, apply parking brake before stopping.