Peugeot 208 2016-2022 Back-up door locking
Back-up door locking
For mechanically locking and unlocking the doors in the event of a fault with the
central locking system or a battery failure.
Driver's door
-
Insert the key in the lock to lock or unlock the door.
Passenger doors
- On the rear doors, check that the child lock is not on.
- Remove the black cap located on the edge of the door using the key.
-
Insert the key into the aperture without forcing, then without turning,
move the latch sideways towards the inside of the door.
- Remove the key and refit the cap.
Deadlocking
(depending on version)
Deadlocking renders the exterior and interior door controls inoperative.
It also deactivates the manual central control button. Therefore, never
leave anyone inside the vehicle when it is deadlocked.
Using the key
- Turn the key to the rear in the driver's door lock.
-
Turn the key to the rear again within 5 seconds to deadlock the vehicle.
Using the remote control
- Press the locking button.
- Press again within 5 seconds to deadlock the vehicle.
Deadlocking is confirmed by fixed illumination of the direction indicators for
approximately 2 seconds. Depending on version, the electric door mirrors
fold at the same time.
From the inside
Locking
Driving with the doors locked may make access to the passenger compartment
by the emergency services more difficult in an emergency.
-
If one of the doors is open, locking of the doors from the inside does not take place.
When locking / deadlocking from outside
-
When the vehicle is locked or deadlocked from outside, the switch does not operate.
-
After normal locking, pull the interior door lever to unlock the vehicle.
-
After deadlocking, use the remote control or the key to unlock the vehicle.
Automatic central locking
The doors can lock automatically while driving (speed above
6 mph [10 km/h]).
Activate / Deactivate
-
Press the button to activate or deactivate the function (enabled by default).
-
This allows the doors and the boot to be locked.
-
The indicator lamp in the button comes on.
Unlocking
- Press the button again.
- The indicator lamp in the button goes off.
-
Press and hold the button until there is an audible signal and/or a message on the screen.
Alarm
The alarm provides the following types of monitoring:
-
Exterior perimeter monitoring
The system checks for opening of the vehicle. The alarm is triggered if
anyone tries to open a door, the boot, or the bonnet.
-
Interior volumetric monitoring
The system checks for any variation in the volume in the passenger compartment.
The alarm is triggered if anyone breaks a window, enters the passenger
compartment, or moves inside the vehicle.
Activation
- Switch off the ignition and get out of the vehicle.
- Press the locking button on the remote control.
Timing
-
Exterior perimeter monitoring is activated after a delay of 5 seconds.
-
Interior volumetric monitoring is activated after a delay of 45 seconds.
-
If an opening (door, boot, etc.) is not closed fully, the vehicle is not locked
but monitoring will activate after 45 seconds.
Automatic activation
(depending on version)
-
Monitoring becomes active 2 minutes after the last door or the boot is closed.
-
To avoid triggering the alarm when entering the vehicle, first press the
button on the remote control before opening a door.
When the alarm monitoring system is active (armed), the indicator lamp in the
button flashes once per second.
Tilt monitoring
-
The system monitors changes in the attitude of the vehicle.
