GARAGE DOOR OPENER
INTRODUCTION
HomeLink Wireless Control System
The universal garage door opener replaces the common handheld garage door opener
with a three-button transmitter integrated into the driver-side sun visor.
How Does The Garage Door Opener Work
The system includes two primary features: a garage door opener and a platform for
remote activation of devices within the home. You can program garage doors, entry
gate operators, security systems, entry door locks, and home or office lighting.
Additional assistance is available online or via customer support.
Garage Door Opener Limitations
Canadian radio-frequency laws require transmitter signals to time out after several
seconds, which may not be long enough for the system to pick up the signal.
Some U.S. gate operators behave similarly.
GARAGE DOOR OPENER PRECAUTIONS AND FREQUENCIES
Garage Door Opener Precautions
WARNING: Do not use the system with any garage door opener that
does not include safety stop and reverse features required by federal standards.
Using non-compliant systems increases the risk of injury or death.
FCC and Industry Canada Compliance
This device complies with FCC Part 15 and Industry Canada RSS-210 regulations.
Operation is subject to interference acceptance and non-interference conditions.
Modifications not approved by the responsible party may void authorization to operate.
Maintain minimum distance requirements for RF exposure compliance.
PROGRAMMING THE GARAGE DOOR OPENER
Clearing the Garage Door Opener
- Press and hold the outer two buttons for about 10 seconds.
- Release when the indicator flashes rapidly.
This clears all stored codes. You may program up to three devices.
Erase stored codes when selling or transferring the vehicle.
Reprogramming a Button
- Press and hold the desired button for ~20 seconds until flashing begins.
- Continue with programming steps below.
Programming to a Handheld Transmitter
- Park outside the garage and switch the vehicle on.
- Select a function button.
- Hold handheld transmitter 1–3 inches away.
- Press and hold transmitter button until indicator changes.
- Press programmed button for two seconds to activate.
- Repeat for additional buttons if needed.
Programming to Garage Door Motor
- Press the motor’s learn button.
- Return to the vehicle.
- Press and hold desired button for two seconds.
- Repeat as required by manufacturer.
Programming to Gate Operator
- Press handheld transmitter every two seconds until indicator changes.
- Release transmitter.
- Press and hold programmed button for two seconds.
- Repeat for additional buttons.
ADDITIONAL ASSISTANCE
- Video setup instructions are available online.
- Support is available through customer assistance channels.
