Adjusting the Steering Wheel
Warning: Do not adjust the steering wheel when your vehicle is moving.
Note: Make sure you are sitting in the correct position.
Use the steering column control:
- Press top or bottom to move the wheel up or down.
- Press front or rear to move the wheel in or out.
- Memory settings allow saving and recalling positions.
Resetting the Stopping Position
- Ensure nothing blocks the steering column.
- Press and hold the control until movement stops.
- Press the control again.
- Continue holding for several seconds.
- Repeat in each direction if necessary.
Horn
Press the center of the steering wheel to activate the horn.
Heated Steering Wheel
Press the climate control button to activate heating. An indicator lights when active.
Note: A temperature sensor regulates heat automatically.
Adjusting the Pedals
Warning: Do not adjust pedals while driving.
- Move pedals farther away.
- Move pedals closer.
- Positions can be saved with memory settings.
Wipers
Precautions
- Do not operate on dry glass.
- Defrost windshield before use.
- Turn off before car wash.
Windshield Wiper Modes
- Single wipe
- Intermittent wipe
- Normal wipe
- High-speed wipe
Autowipers (If Equipped)
Automatically controls wipe speed based on rain detection.
- Settings → Vehicle → Wipers
- Switch Rain Sensing on/off
Rain Sensor Sensitivity
- High sensitivity: reacts to light rain
- Low sensitivity: reacts to heavier rain
Rear Wiper
- Off
- Intermittent
- Continuous
Reverse Wipe
Activates rear wiper when reversing if front wipers are active.
Replacing Wiper Blades
- Lift wiper arm.
- Remove blade.
- Install new blade securely.
Washers
Warning: Use antifreeze washer fluid in cold temperatures.
- Do not run washer dry.
- Keep windshield clean for sensor accuracy.
Using Washers
- Pull lever for windshield washer.
- Push lever for rear washer.
Courtesy Wipe Settings
- Settings → Vehicle → Wipers
- Switch Courtesy Wipe on/off
Exterior Lighting Control
- Headlamps on
- Autolamps
- Parking lamps
- Lamps off
Headlamps
High Beams
- Push lever forward to activate.
- Pull back to deactivate.
- Tap to flash.
Exit Delay
Pull turn signal lever after shutdown to enable delayed headlamp shutoff.
Autolamps
Warning: Always monitor visibility — override system if needed.
Automatically activates headlamps in low light or rain.
Exterior Lamps
Turn Signals
- Move lever up/down.
- Tap for three flashes.
Daytime Running Lamps
Settings available depending on vehicle configuration.
Warning: DRLs do not activate rear lamps — use headlights in low visibility.
Front Fog Lamps
- Activate when headlamps or parking lamps are on.
- Use only in reduced visibility.
Welcome Lighting
Exterior lights activate when approaching or unlocking vehicle.
Automatic High Beam Control (If Equipped)
Warning: Driver remains responsible for safe operation.
Automatically switches high beams based on traffic and lighting.
Requirements
- Autolamps active
- Low ambient light
- No detected traffic
- Vehicle above minimum speed
Override
Use steering lever to manually control beams.
Glare-Free Lighting (If Equipped)
Enhances visibility while minimizing glare for others.
Activation
- Settings → Vehicle → Lighting
- Switch feature on/off
Adaptive Front Lighting
Adjusts beam direction during curves for improved visibility.
