Multifunction Lever
The multifunction lever controls turn signals, headlight beam selection, overtaking lights, and windshield/liftgate wipers and washers. It is located on the left side of the steering column.
Turn Signals
- Move the lever fully up or down until it clicks to activate turn signals.
- Instrument cluster arrows flash to confirm operation.
- Tap the lever lightly for lane-change function (three flashes).
NOTE:
- If a signal stays on or flashes rapidly, check for a faulty bulb.
- A chime sounds if driving more than 1 mile (1.6 km) with a signal active.
High Beams and Flashing
- Push the lever forward to activate high beams when headlights or AUTO mode are active.
- Pull the lever back to return to low beams.
- Pull slightly toward you to flash headlights for signaling.
CAUTION: High beams must be activated manually by pushing the lever forward.
WARNING: Switch off high beams when no longer needed to avoid dazzling other drivers.
Interior Lights
Interior and approach lights illuminate when entering or exiting the vehicle and automatically turn off after 10 minutes to protect the battery.
- Brightness can be adjusted through steering wheel controls.
- Available settings include backlighting and ambient lighting.
Automatic Headlights Leveling
The vehicle automatically adjusts headlight beam level according to load and ride height to ensure proper visibility and safety.
Dome Lights
- Central dome light turns on automatically when doors open.
- Reading lights operate via side buttons.
- Lights remain on briefly after engine shutdown and then fade off.
NOTE: Dome lights also activate when locking/unlocking the vehicle with the key fob.
Cargo Lights
Liftgate and trunk lights illuminate when the liftgate opens and turn off after approximately 30 minutes if left open.
Hazard Warning Flashers
- Press the central console button to activate hazard flashers.
- Turn indicators and instrument cluster arrows flash simultaneously.
NOTE: Turn signal controls are disabled while hazard flashers are active.
Mirror Integrated Lighting
External mirrors include LED turn signals and optional courtesy lighting that activate with entry/exit lighting.
Wipers and Washers
The multifunction lever operates windshield and liftgate wipers and washers when ignition is in RUN or ACC.
CAUTION:
- Turn wipers off before automatic car washes.
- Ensure blades are not frozen to the windshield.
- Remove snow buildup to prevent motor damage.
Windshield Wipers
- Rotate lever end to select intermittent, low (LO), or high (HI) speed.
- Rotate backward to MIST for a single wipe.
- Rotate to OFF to stop wipers.
Rain Sensing Wipers
The rain sensor automatically adjusts wiping speed based on moisture detected on the windshield.
- Four sensitivity levels are available.
- Turn off when automatic operation is not desired.
CAUTION:
- Ice or salt may affect sensor performance.
- Wax or silicone products can reduce sensitivity.
Headlights On with Wipers
Headlights automatically turn on about 10 seconds after wipers activate when the light switch is in AUTO mode.
Wiper Blade Maintenance
To service blades, place the lever in OFF and ignition OFF, then move the lever to MIST to position blades for access.
WARNING: Always use service position before working on wiper blades to avoid accidental activation.
Windshield Washers and Headlight Washers
- Push the lever inward to spray washer fluid.
- Wipers perform additional cycles after spraying.
WARNING:
- Do not use washer fluid on a frozen windshield.
- Sudden visibility loss may cause accidents.
Headlight Washers
Headlight washers operate automatically every 11 windshield wiper cycles when headlights are on.
Heated Washer Nozzles (Optional)
Heated nozzles prevent washer fluid from freezing in cold weather.
Rear Window Wiper/Washer
- First detent activates intermittent rear wiping.
- Second detent activates continuous wiping.
- Further rotation sprays washer fluid.
- Backward rotation triggers washer cycles and returns to OFF.
