CHARGING THE TRACTION BATTERY
General Information
Charging consists of connecting the vehicle to a domestic power point or a public charging point. Before making any connection, ensure that the electrical installation meets standards and is compatible. Specifically, check that the power point is suitable for electric vehicles. Initial and regular checks by a qualified electrician are recommended.
Connecting the Normal Charging Cable
- Use the charging cable supplied with the vehicle.
- Use a compatible power point (with earth, clean, and in good condition).
- Do not use an extension cord, multi-gang socket, adaptor, or timer.
Charging time: 7 hours 30 minutes to 15 hours for a complete charge. Charging can be interrupted at any time and stops automatically when the battery is fully charged.
Normal Charging – Country Specifics
| Drive |
Country |
Current Rating |
Plug Type |
| Left-hand | Denmark (DK) | 8 A | K |
| Left-hand | Switzerland (CH) | 8 A | J |
| Left-hand | Other countries | 8/14 A | E/F |
| Right-hand | All | 10 A | G |
Cables for Normal Charging
- Mode 2 cable: delivered with vehicle.
- Mode 3 – Type 2 cable: accessory.
- Mode 3 – Type 3 cable: accessory.
Check compatibility of domestic and public electrical installations for safe charging. Never touch the metal end of the charging socket or cable. Use the cord supplied to hook the control unit to avoid weight on the power point.
Safety Precautions
- Never connect/disconnect cable or plug with wet hands.
- Press Manual Stop on controller before disconnecting if interrupting charge.
- Controller indicator lamps:
- STOP (red): Charging interrupted.
- POWER (green): Power supply established.
- CHARGING (green): Charging in progress.
- FAULT (red): Fault detected.
Normal Charging Procedure
- Ensure drive selector is in P and ignition is off.
- Open access flap on right front of vehicle.
- Connect controller end to compatible power point.
- Check that POWER indicator stays on.
- Remove protective cover from charging cable and insert plug until it clicks.
- Press push button to open socket cover if required.
- Check instrument panel charging lamp and controller CHARGING indicator.
- Charging interrupts motor start for safety.
- Recharge completely every 15 days for battery maintenance.
Disconnecting
- Check charging lamp and controller indicator to confirm charge complete.
- Close socket cover and access flap.
- Disconnect controller from power point and stow
