The door key lock cylinder turns freely when either the wrong mechanical key is used, or the correct mechanical key is not fully inserted. The free-turning door lock feature prevents the lock from being forced open. To reset the lock, turn it to the vertical position with the correct mechanical key fully inserted. Remove the mechanical key and insert it again. If this does not reset the lock, turn the mechanical key halfway around in the cylinder and repeat the reset procedure.
If equipped, to close any door, gently push or pull it until the power cinch motor draws the door the rest of the way closed and latches. Pull the handle during a soft-close to cancel the cinching and re-open the door.
Press Q or K on the remote key. See Remote Keyless Entry (RKE) System Operation 0 7.
A light on the upper surface of the driver's door trim indicates vehicle security status:
This feature delays actual locking until five seconds after all doors are closed. Pressing Q on the power door lock switch while a door is open sounds a three-chime alert. Doors lock automatically after 5 seconds. Opening a door resets the timer. Press Q again to override and lock immediately. Can also be programmed via Vehicle Personalization 0 140.
Doors lock automatically when all doors are closed, ignition is on, and vehicle is shifted out of P (Park). Unlocking:
Automatic door unlocking can be programmed; locking cannot be disabled. See Vehicle Personalization 0 140.
If ignition is ON or in ACC/ACCESSORY and power door lock switch is pressed with driver door open, all doors lock and only driver door unlocks. If vehicle is off, system checks for remote keys inside and unlocks driver door if keys detected. Manual override: press and hold Q on power door lock switch.
Rear door safety locks prevent passengers from opening rear doors from inside:
To open with safety lock on:
To cancel safety lock:
The liftgate switch is on overhead console. Vehicle must be in P (Park). Modes:
To operate liftgate:
Stop operation: press any liftgate button, emblem, or b on remote key. Restart operation: press again in same or reverse direction.
The power liftgate may disable temporarily in extreme low temperatures or after repeated cycles. Vehicle shifted out of P while power function in progress continues to completion.
If liftgate closes automatically after power opening, excess weight or support strut failure is detected. Repetitive chime sounds. Remove excess weight or consult dealer if persists. Interfering or manually closing liftgate too quickly may trigger detection feature.
If liftgate encounters an obstacle during power cycle, it reverses direction. Multiple obstacles deactivate power function temporarily. Remove obstruction to resume operation.
Move foot forward near center of rear bumper within 14 cm (6 in) of bumper, then pull back. Step away after activation.
Short delay and taillamp/chime occurs when closing with this feature. Feature may be temporarily disabled in certain conditions.
If equipped, vehicle logo projects onto ground near rear bumper for 1 minute when remote key detected within 2 m (6 ft). Zone for kick: 1 m hands-free, 2 m projected logo.
Projected logo will not restart unless remote key out of range >20 seconds. Conditions preventing projected logo:
Projected logo will not work for a single remote key if left near liftgate >5 m, inside vehicle, or approaches outside liftgate >5 times in 10 minutes.
