Turn the end of stalk 1 until the symbol is opposite mark 2.
Turn the end of stalk 1 until the symbol is opposite mark 2. An indicator light on the instrument panel will come on.
With stalk 1 in dipped beam headlights position, move the stalk towards you. When the main beam headlights are lit up, an indicator light on the instrument panel lights up. To return to the dipped headlight position, pull the stalk towards you again.
Return the end of stalk 1 to its initial position.
A warning buzzer will sound when a front door is opened and the lights are left on after the ignition has been switched off (to prevent discharge of the battery).
Before driving at night, check that the electrical equipment is operating correctly and adjust the headlight beams (if your vehicle is not carrying its normal load). Check that the lights are not obscured (by dirt, mud, snow or objects which could cover them).
Turn centre ring 3 again until the symbol for the fog light or for extinction position is opposite mark 4. The corresponding indicator light on the instrument panel goes out. The front and rear fog lights switch off when the exterior lights are switched off.
Turn the centre ring of stalk 3 until the symbol is opposite mark 4. The fog lights only light up if the exterior lights have been switched on. An indicator light on the instrument panel then lights up. Do not forget to switch off the fog lights when they are no longer needed, to avoid inconveniencing other road users.
Turn the centre ring of stalk 3 until the symbol is opposite mark 4. The fog lights only light up if the exterior lights have been switched on. An indicator light on the instrument panel then lights up. Remember to switch off these lights when they are no longer required to avoid inconveniencing other road users.
Examples of positions for adjusting control A according to the load:
Control A is used to adjust the height of the headlight beams according to the load. Turn control A anticlockwise to lower the beams and clockwise to raise them.
With the ignition on, move stalk 1 around the steering wheel:
With the ignition on, pull stalk 1 towards you. A brief pull will trigger a single sweep of the wipers, in addition to the windscreen washer. A longer pull will trigger three sweeps of the wipers, in addition to the windscreen washer. In frosty weather, ensure that the wiper blades are not stuck by ice (risk of motor overheating).
Keep an eye on the condition of the blades. They should be replaced as soon as they become less efficient. This will occur approximately once a year. Clean your windscreen regularly.
If you switch off the ignition before switching off the windscreen wiper (position A) the blades will stop at random on the windscreen. After switching the ignition back on, simply move stalk 1 to position A to place them in the park position.
Before touching the windscreen (washing the vehicle, de-icing, cleaning the windscreen, etc.), move stalk 1 to position A (park). Risk of injury and/or damage. When working in the engine compartment, ensure that the windscreen wiper stalk is in position A (park).
With the ignition on, turn the end of stalk 1 to align the symbol with mark 2. Before using the rear wiper, check that no object is obstructing the travel of the blade. In frosty weather, ensure that the wiper blades are not stuck by ice (to avoid the risk of the motor overheating).
Keep an eye on the condition of the blades. They should be replaced as soon as they become less efficient. This will occur approximately once a year. Clean your windscreen regularly.
With the ignition on, turn the end of stalk 1 to align the symbol with mark 2. When the stalk is released, it returns to the th...
