Storage Compartments
Warning: Do not store heavy or sharp objects in storage compartments. In a crash, these objects may cause the cover to open and could result in injury.
Glove Box
To access the upper glove box, pull up on the handle. To access the lower glove box, unlock with the key and pull down on the handle.
Cupholders
Front
There may be cupholders on the center front seat console armrest.
Rear
If equipped, pull the rear seat armrest down to access the cupholders.
Underseat Storage
There may be storage under the rear passenger seat. Lift up on the seat bench to access. Push the seat bench toward the floor to close.
Rear Storage
There may be storage in the rear seat. Pull the tab to access. Push the storage door to close. The storage door must be closed before installing child restraints.
Center Console Storage
Bench Seat
Pull the strap on the side of the center seatback to access the storage area and cupholders. Do not use the center seatback as a seating position when the seatback is folded down.
To raise the seatback, push the seatback rearward until it locks in the upright position. Push and pull on the seatback to make sure it is locked.
Bench Seat (if equipped with storage)
Press the latch and lift to open.
Bucket Seat
Press the latch and lift to open.
Floor Console Storage
If equipped with front center seat storage, unlock with the ignition key, press the latch, and lift to open.
Additional Storage Features
Cargo Tie-Downs
This vehicle is equipped with 12 fixed cargo tie-downs.
Caution: The truck bed walls will collapse if the tie-downs are overloaded. Any of the 12 locations inside the truck bed can be used. The maximum load per corner is 227 kg (500 lb).
Accessory Tie-Downs
Additional Accessory Tie-Down Points: Any of the nine holes inside the truck bed can be used for tie-downs. The maximum load is 113 kg (250 lb) per tie-down.
Caution: The truck bed walls will collapse if the tie-downs are overloaded.
To Install:
- Insert a tie-down loop assembly until it is flush with the truck bed wall.
- Turn the tie-down loop clockwise to tighten. The tie-down will be hard to turn until the toggle moves past the installation point on the toggle guide.
- Fasten the tie-down firmly by hand only. Do not use tools.
To Remove:
- Remove the tie-down loop completely by turning counterclockwise while holding the backing plate against the truck bed wall.
- Pull the backing plate away from the truck bed wall until a click is heard. This locks the toggle into position on the toggle guide.
- Push the backing plate against the truck bed wall. This allows the toggle nut to spin.
- Remove the ba
