Interior lights
-
Sun visor lamps: Switch on or off as required using the switch.
-
Puddle lamps: Automatically illuminate when the doors are opened.
-
Map reading/interior lamps:
- A. Map light controls (on/off).
-
B. Main interior lamp control (on/off/Auto). To activate or deactivate
Auto mode, press and hold for longer than 3 seconds. In Auto mode the
lamps will illuminate when a door is opened.
-
Rear interior light control:
- A. Map light controls (on/off).
-
B. Main interior lamp control (on/off/Auto). To activate or deactivate
Auto mode, press and hold for longer than 3 seconds. In Auto mode the
lamps will illuminate when a door is opened.
-
Third row seating/loadspace interior lamps:
- A. Press to turn off.
- B. Press to turn on.
Wipers and washers
-
Rear window wash/wipe: Press and hold to operate the rear washer and wiper.
The wiper will operate for two further wipes after the button is released.
After a few seconds a drip wipe process will clear any residual water.
-
Single wipe of windscreen, or hold down for further continuous wipes.
-
Windscreen wash/wipe: Pull and hold to operate the front washers and wipers.
The wipers will operate for three further wipes after the stalk is released.
After a few seconds a drip wipe will clear any residual water.
-
Rear wiper: To operate, rotate to ON.
Do not operate the windscreen wipers on a dry screen.
In freezing or very hot conditions, ensure that the wipers have not stuck to
the glass.
Remove any snow, ice or frost from the screen, around the wiper arms and
blades, and the screen scuttle before operating the wipers.
Note: If the wiper blades become stuck or jammed, an
electronic cut-out may temporarily halt wiper operation. If this happens,
switch off the wipers and the ignition. Clear any obstructions and free the
wiper blades before attempting to switch on the ignition.
Speed-dependent mode
If vehicle speed drops below 8 km/h (5 mph) with the wipers operating, the
wipers will switch to the next lowest speed. When vehicle speed increases to
over 8 km/h (5 mph), the original wiper speed setting is restored
automatically.
In vehicles not fitted with a rain sensor, the frequency of intermittent wipe
adjusts according to vehicle speed.
Wiper operation
Feature (1) can be enabled or disabled by your Dealer/Authorised Repairer.
-
Intermittent wipe delay: Rotate the control to adjust the intermittent
period. The intermittent delay period will vary and is controlled by either
vehicle speed or a rain sensor. The control must be in position (4) to be
operational.
-
High speed wipe.
-
Low speed wipe.
-
AUTO or intermittent wipe: AUTO is controlled by either a rain sensor or
vehicle speed. In this position, the rain sensor becomes active and will
determine when the wipers are required to operate. If your rain sensor is
not configured by your Dealer/Authorised Repairer, intermittent wipe will
operate in conjunction with the setting of control (1).
