Lift lever A fig. 13 and push the seat forwards or backwards.
IMPORTANT: Carry out the adjustment while sitting on the seat involved (driver side or passenger side).
Move lever B upwards or downwards to achieve the required height.
IMPORTANT: Carry out the adjustment while sitting on the seat involved (driver side or passenger side).
Move lever C to adjust the backrest angle, accompanying it with the movement of the torso (operate the lever until the desired position is reached, then release it).
When the ignition device is at MAR, press button A fig. 14 to adjust the lumbar area support, until the maximum driving comfort is achieved.
The buttons for electrical seat adjustment are on the outer side of the seat, near the floor. These buttons can be used to adjust the height, the lengthwise position in relation to the vehicle, and the angle of the backrest.
Use the front or rear part of the switch A fig. 15 to modify the height and/or the angle of the seat cushion.
Push switch A forwards or backwards to move the seat in the corresponding direction.
Push switch B forwards or backwards to adjust the backrest in the corresponding direction.
Use the joystick C to actuate the lumbar area device until the maximum driving comfort is achieved.
IMPORTANT: The electrical adjustment is only allowed when the ignition device is turned to MAR and for about 3 minutes after it is turned to STOP. With the vehicle at a standstill, after passing from closed door to open door, adjustment will be possible for 3 further minutes.
With ignition device at MAR, press buttons fig. 16 on the dashboard.
You can select two heating levels:
After selecting one heating level, you need to wait for a few minutes until warm air flows into the compartment.
When the "maximum heating" setting is selected, the heater produces a boosted heat level for the first minutes of operation.
IMPORTANT: To preserve the battery charge, this function cannot be activated when the engine is off.
To partially extend the boot, follow these steps:
Accompany the backrest during folding.
Move the seat belts to the side, making sure that they are correctly extended and not twisted.
Raise the backrests and push them back until the locking click of both retainers is heard. Visually check that the red marks have disappeared from the release devices A fig. 17. The red marks indicate that the backrest is not secured.
WARNING: Any adjustment must be performed with the vehicle at a standstill.
WARNING: After releasing the adjustment lever, always check that the seat is locked on the guides by trying to move it back and forth. If the seat is not locked into place, it may unexpectedly slide and cause the driver to lose control of the vehicle.
WARNING: Make sure that the backrests are correctly secured on both sides ("red marks" not visible) to prevent it from moving forward in the event of sharp braking, causing injuries to occupants.
The fabric upholstery for the seats has been designed to withstand long-term wear derived from normal use of the vehicle. Nevertheless, some precautions are required:
WARNING: Before tilting the backrest, remove any objects lying on the seat.
